happymodel superx hd elrs 1-2s aio kontroler lotu zastosowanie 12a blheli_s 4w1 esc i podanie uart elrs

flight controller superx hd elrs
-betaflight 4.4.2 firmware ready;
-firmware target: crazybeef4dx;
-mcu: stm32f411ceu6 (100mhz, 512k flash);
-sensor: bmi270 or icm42688p (spi connection);
-power supply: 1-2s lipo lihv battery input (dc 2.8v~8.7v), only support 1s input for this dron//;
-built-in 12a(each) blheli_s 4in1 esc dshot300 read;
-built-in uart elrs receiver, elrs v3.0 ready, support wifi and pass-through firmware update;
-bluejay esc firmware ready;
-built-in 5v 1.5a(max) bec;
-built-in voltage detectionbuilt-in currents meter;
-no betaflight analog osd chip;
antenna: enamel copper wire

onboard 4in1 esc
-power supply: 1-2s lipo/lipo hv;
-current: 12a continuous peak 15a (3 seconds);
-support esc-configurator and blheli_s suite configurator;
-factory firmware: z-h-30-bluejay, 0.19, 48khz;

onboard uart expresslrs 2.4ghz receiver
-rf frequency: 2.4ghz
-antenna: enameled copper wire 31mm length
-telemetry output power: <12dbm
-receiver protocol: crsf
-default firmware version: expresslrs v3.0.1
-the same hardware with happymodel ep1 receiver
-could update firmware via expresslrs configurator or wifi or betaflight pass-through
default protocol: dshot300